wiper fluid RENAULT KANGOO 1997 KC / 1.G Electrical Equipment Workshop Manual

WIPERS
Electric washer pump
85
This vehicle is fitted with a bidirectional electric
pump (E) which feeds fluid from the same reser-
voir to both the front and rear screen washers ac-
cording to the electrical feed to the two track
connector (D).
Two cases may be considered:
13069R2
Track Feed
A + 12 Volts
B Earth
The pipes are fed via the white end piece (1)
whilst the front windscreen washer is in opera-
tion.
Track Feed
A Earth
B + 12 Volts
The pipes are fed via the black end piece (2) whilst
the rear screen washer is in operation.
DI8503
REMOVAL - REFITTING
To reach the washer pump it is necessary to re-
move:
- the wiper arms using tool Elé. 1294-01 after no-
ting their positions,
- the scuttle panel grille seal,
- the scuttle panel grille after removing the two
side covers and the two bolts and disconnecting
the front washer pipe.
When removing the washer pump (E), mark the
two pipes (1 and 2) before disconnecting them.
Special notes for refitting
Check that the motor is in the park position be-
fore refitting the wiper arms.
Clean the splines on the wiper arm pins using a
metal brush.
Refit the wiper arms, locating the blade on the
marks made on removal.
Fit new nuts and torque tighten to 1.8 daN.m (±
15 %) using a torque wrench.
85-4